HOCHANDA

Tonic Studios Waterfall Slider Cards by Sherrill Willis – HOCHANDA

admin 21 April 2019 0Comments

First, you need to cut out the mechanism and attach that to whatever base you’ve decided to use. I stumbled a bit here, until I realised I needed a base

Tonic Studios Floral Flavour Octagon Card by Tracy Sutton – HOCHANDA

admin 21 April 2019 0Comments

You will need:

Stage 1: Cut out the largest die in the set that will fit onto the card front and thread silver ribbon through the holes. Tie in a

Crafter’s Companion and Sheena Douglass: A Review by Sharon Holden – HOCHANDA

admin 21 April 2019 0Comments

I have had lots of fun playing with all these products as of course I’ve not tried a lot of these previously. I have found them to be of good

Cardmaking with the ‘Diamond Lattice Background Die’ from Craft Buddy by Sharon Holden – HOCHANDA

admin 21 April 2019 0Comments

Shop here

For this card you will need:

To make the card you:

1. Cover your 8” x 8” card blank with red mirri card. Top tip: if you’re like

Spellbinders Pop-Up Boxes by Sherrill Willis – HOCHANDA

admin 20 April 2019 0Comments

I’m kind of obsessed with these right now, and have made quite a few. I will show a few pictures at the end of some others that I have done,

Craft Buddy Crystal Art Unicorn Motif Project by Tracy Sutton – HOCHANDA

admin 20 April 2019 0Comments

Stage 2: Cut a two circles of card stock using the circle dies and mat and layer one on top of the other. Stick on the plaque towards the right